DTFJUNKIE
-
Posts
3 -
Joined
-
Last visited
Content Type
Profiles
Forums
Gallery
Store
Downloads
Blogs
Events
Articles
Posts posted by DTFJUNKIE
-
-
1 hour ago, johnson4 said:
45 amps at 120V is wild. Your standard 200 amp whole house service can only handle around 100 amps per side. So you will likely have a unbalanced electrical box.
just look on Amazon for dz47le-63. That’s a 63 amp breaker. They are like $17.
That’s a fault breaker, so it could be doings it’s job and protecting you. I’d be careful.
every shaker I’ve used had an issue new out of the box in some form. You’ll also run across needing to repair them often. Best to get to know it now, then later.
-
So like on title had it for 3 weeks. I finally got wired up correctly. It's a 110v@45.5 amps. Double check with vendor. Calibrated printer, feed film through, got everything going. And then..... just shuts off after like 15min. Looked inside the breaker/relay was tripped. So I reset, hit the switch and turn power on and major let down, heard breaker tripped. Yes the one inside the shaker. Is this the problem I've just read about in another post.refer to pic. Any help on where I can get quality replacement part would be appreciated .any help and or advice. I'm all ears.TIA. And yes I do smell burnt electric something. Like I said too, brand spanking new. Didn't even get to cure One gang sheet.
Brand new shaker stopped working , WTF!!
in Dryers, Shakers, Ovens and other DTF curing equipment.
Posted
Like u said I think it's doing its job, but I think it's something else that's fried. I'll be looking around to see what I find. Darn shame though.