Jimmy Stanley

i would love to see pictures of this conversion kit please

my inline dampers don't fit in the rubber boot tight, so im going to get creative.

yei did order some 

Quote

yes, i like yours as well. i found the post you referenced and reached out to the OP. seems the inline dampers i have don't fit tight and he said he superglued them. i lost my dang cheapo harbor freight calipers, so i need a new set. i am going to go forward with your original idea. i am really curious about how you were planning to do the waste tank/ink reset,, my printer does not pause when it runs out of ink (i have seen one person that showed a video of hers pausing mid print for her to reset the ink) mine just wants to eject/feed the roll of film out until it stops with a "paper jam".  i did find some closed cell neoprene foam so now i need to measure the rubber boot so i can make an svg and cut some with the laser.....i hope 1/6th was correct, 1/8 seemed to thick, but in retrospect it might make for a better seal.  i was comparing the et8550 dampers, and thought about trying to retro fit them, but can not seem to find replacements for them. anyway, if you come across your original file, i'd still love it, and any more info you have to pass along.

one more thing i am looking to change is the stupid weak spot where the chip reader screws into the carriage on the back. i considered trying to remove the carriage and 3d print a more robust version, but the removal process looks a little daunting.

On 10/5/2022 at 7:06 AM, Mr.Carter said:

Most of xp15000 printer endup with 031006 error within a month. The error is about printhead failure. This is Due to these Chinese cartridges keep leaking slowly when you install it or when you remove it for refilling and all the ink goes inside the headcable destroy the printhead and motherboard at this point its like you destroyed the whole printer as motherboard and printhead is expensive

 

here is the solution for that this damper on the cartridge wouldn't let the ink to flow unless the suction is generated by printhead so no leaks keep in mind you have to install it on top of the cartridge only. inline with pipe didn't work as good as this thing work

i have tested it for 4 months of use no issues yet

 

Can you show me a picture of your finished setup with theseand how you have it setup with gravity feeding? also, are you sealing the inline dampers to the aftermarket cartridges or do they just plug into the little rubber boot thet the piplines normally plug into?

i'll have to find the post about the OEM and damper. i found one using aftermarket carts and inline damper

oh i understand, this last few months with the holidays kicked my butt too. i will have to look for the other post you are talking about. i also started with my calipers and haven't finished the one i started either, lol! thanks for the response

Just checking to see if you were able to find the 3d files you  started?

Any luck finding the old files?