Heaven867693

On 3/3/2024 at 5:20 PM, nedlaidi26 said:

Can you please share the code with me?

nedjmeddine.laidi26@gmail.com

 

Thank you in advance 

I use the code on the forum

contact me via email: phamthaingoc13579@gmail.com

18 hours ago, Almegdad said:

Well done 

I want to build a printer like this one 

Will give me support and guidance even with fees please 

Does it use cmykw or cmykw vanish? sorry for my english

When you put 10 prints in the same location, is it a stack of copies in the same location?

i usually make with epson l1800 for a3 size, it has no ink chip and does not discharge ink on the left side. I think this machine is very good

I come from Vietnam. this is a uv printer l1800 i made myself based on the source code in the forum, thank you

awesome, i think so too, hahaha 😝

My printer's printing area is 30x65cm, the maximum material thickness is 10cm. mays has a vacuum table support and displays the height of the printed object with an electronic ruler

Thank you sir!

You should choose a color icc that matches the size of the large and medium ink particles.  this is the print i printed with uv l1800 machine on clear plastic

I got an 80% reduction in the print's stripe

I think maybe it's the ink.  because when i use ink bought in my country i never had that error,icc profile only decide part,because in same print,when i change icc profile picture quality will be different

If you use high power uv lamp, it is easy to cause heat.  45w is enough in my opinion.  UV lamp to be about 2cm away from the printed object.  If it is too close, it will cause the printed object to warp, if it is too high, it will not dry.  i use 45w lamp and air cooled.  Your case I think is caused by ink or related to icc profile

sorry for my english.  If you use UV ink, you have to replace the ink feeder, ink guide for UV.  UV lamp should choose 45w.  There are many wavelengths of light, you should choose the right one for your ink, I use 395nm.  otherwise the ink will not dry at the same wavelength

this is my printout on my uv l1800 machine.  i use acrorip 10.5.  no stripes at all

On 3/17/2023 at 6:09 AM, sem30 said:

That’s a very nice print.

Thank you ! 

Can you share this code ?

This is my uv l1800. 30cm x 65cm x 12cm

On 12/6/2021 at 8:26 PM, josualo said:

Hello, I am using it with an Epson without a flatbed, it can be done in several ways, one print on the film that already has glue, another is to print on an acetate and put glue in a channel, then with another pass send the color along with the target.

What type of the glue sir?

On 5/9/2021 at 12:52, Joel Towers said:

Nó được sản xuất để in giấy cuộn, ngay sau khi in xong, nó sẽ đóng mô phỏng cảm biến nguồn cấp dữ liệu và tự động cuộn giấy rút lại và tự chứa cho lần in tiếp theo.
 

can you share it sir?

Thank you sir!