Kevint1272

1 hour ago, johnson4 said:

It's around here somewhere, if not I can send it over to you in a bit. 

Ok. Thank you!

On 11/7/2021 at 2:52 PM, johnson4 said:

You need to install the form feed file for EKprint, and make some sort of roll holder for the film. The first time you load the film, it loads like a sheet of paper. After that, it doesn’t spit the film out. You set the gap between the prints in EKprint. 
 

just be sure to watch your ink levels, it will spit the film out if they run out while it’s loaded. The trick around it, pause your print job in windows print queue when it’s low, when the last print finishes, just pull out and put in the waste tank- this resets the ink. 
 

Refill your ink if needed of course, resume printing in windows, repeat. 
 

you also unfortunately cannot do a head clean while the film is loaded, not at least when I did it.

Where do I get the form feed file for EKprint?